Electronic Control Systems and Parts

Balboa Expander circuit board used to add a 2 speed pump output to the VS520SZ, VS520DZ, BP7, LPI501ST, and BP501 based circuit boards and spa packs. This board is found mounted on top of the heater. Includes 30 amp fuse protection. This circuit board...

Temperature sensor for the Jacuzzi J-400 and J-1000 models from 2010 - current that uitilize the Nidec Spa pack that has the different colored rubber molded plugs, called a DSMT plug. This sensor has the typical hex head mount for the sensor and has a 8...

Balboa "Y" Splitter used to add an additional Pump # 4 on BP spa packs and control systems such as the BP7 and BP2000. To utilize this splitter you plug the male end into the Pump 2 port, go into the programming and set pump 2 as a 2 speed circuit, then...

This Plumbing & Glue kit is used to change from a Cal Spa Dually Pump setup to a single Pump set up since the dually pump has been discontinued.. You will have to modify the plumbing and note that this kit is for most applications and may not be...

This part is a 72" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade connector off the end off the end and attach with crimp connectors.  The Wire colors are...

This part is a 60" AMP Style 3 Wire Cord With Male Plug that is used on a 1 speed pump or blower.. Note: To use this cable with a blower you will cut the spade connector off the end off the end and attach with crimp connectors.  The Wire colors are...

This part is a Amp Cord, Pump 1, 2-Speed, 4-Pin Amp, 14/4, 96" Long, Plug Attached, w/Terminated Ends. The Wire colors are as follow on most systems: Red=High Speed Black=Low Speed White=Neutral or Common Green=Ground There are exceptions to these...

HydroQuip Temperature Sensor, 72" with 1/4" diameter temp probe. Common to find these used on the Versi Heaters and 9700 series spa controls. For SSPA, USPA, MP, 6200, 9200, 6500, 7500, 8500, 9500, 9700, 6330, 9330 series of spa packs and controls by...

Temperature Thermister, aka temp sensor for the Watkins made Solana and Hot Spot hot tubs from 2003 forward. This sensor has a 3/8" bulb and a two wire, four pin JST plug that connects to the circuit board. Its job is to communicate the temperature to...

Popular plastic presssure switch for use with many brands of hot tubs and spas. Common to find thsi switch on Cal Spas and some ACC control systems. Comes preset at 1.5 psi but is field adjustable from 1-11 psi. Be sure to add teflon tape to your threads...

Blower adapter cord made to cleanly adapt a 4 pin amp plug to the the rubber molded Mini J&J (MJJ) style plug with 6" cable. No longer comes with clear purple lit end, now solid black. Cord Type Adapter, Adapter Cord Appliance Blower Cord...

This part is a Cable and Plug for an In.Link on system on IN.XE and IN.XM systems Aeware Gecko. The cable is for Pump 1, 2-Speed, 15A, 230V, 8' Cord. Cord Type Cord Appliance Pump, 2-spd Pump Cord Length 8ft, 96" Male End Plug Style in...