Electronic Control Systems and Parts

In this video The Spa Guy tells you the basics about diagnosing and replacing a M7 sensor on a Balboa Board.  Click this link for the m7 sensors on this site: M7 Sensor #sparepair #hottubrepair #spaguy...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This Item is a Board Fuse .05Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/8" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You...

This part is a Terminal Block 6 Position 40A 115 or 230V.. that fits Balboa Duplex Digital and Super Digital Board System with (6) Tabs to connect the board to the components.. 6 position terminal block 5-3/16" overall length.

This part is a Electronic Pressure Switch for Watkins Solana, Caldera & Hot Spot, 2006 Thru Current that features 1/8th" MPT Standard Threads and 2 pin connectors for attaching the 2 wire 3 hole connector for a Watkins board. What goes...

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa B2DG and B240 Systems.   Circuit Board Application    Balboa Water GroupCircuit Board Model    B2DG, B240Circuit Board...

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole...

This part is for a Set of (2) Standard Balboa Board Replacement Repair Relay made by Zettler. This Relay is the standard relay found on most Balboa Boards but it has double tabs on it so you can add jumpers from the tabs to the feed and load side of the...

This part is no longer available.. This part is a 5 pin Male side Amp connector 20 Amp . This part is normally found on the Cord side that would come from a pump or blower or other accessory. Note: You will need a pin tool to replace this part to...

This part is a 5 pin female side Amp connector 20 Amp . This part is normally found on the control pack side mounted for the male amp cord that would come from a pump or blower or other accessory. Note: You will need a pin tool to replace this part to...

This part is the Control Box Board Side Female AMP Connector that houses (2) Female Pins.. The Pins are not included.. This connector is used often on light cables.. Terminal Type AMP Terminal Style AMP Plug Housing Female Number of...

This part is an Adapter Kit to convert the new style sensor set for Watkins No-Fault 4000 or 6000 heaters to the old style plugs.. Includes: The Two Adapters only for the Sensors click the link below: Below is a list of related parts click on the links...