Electronic Control Systems and Parts

Temperature sensor mount for older Sundance 601-605 and 624 systems. Can also be used for other sensors with a 3/8" diameter. The male thread on this sensor mount is 1/2" Mpt   Heater Part Type Strain Relief Manufacturer Heyco Defining...

MDA Series Slo Blo FuseCeramic construction for protection of loads to 30 amps

Right Angle GFCI PlugDesigned for protecting spa units- keeps cords snug against the wall. Provides ground fault and open neutral protection

This item is a 1/8" MPT Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or the...

This part is an Amp Style Male Pin crimp connector that fits wire that is 14-20 Gage and is usually found on the pump or other accessory side plug connector that is mounted on the cable.. This listing is 25 Pins..   Terminal...

Mini Size Pump Female Receptacle4 leads, 9" long, 14 AWG

This part is a Temperature Sensor For 6200, 6220, 6230, 6330, 7500, 9700 Control systems. Used On: SSPA-SC-CF/MSPA-MP LINE Replacement Option For:AI #5-60-6021 / MFG #9920-400723AI #5-60-6066 / MFG #9920-400262 (3-Wire) Sensor Application Spa...

Plug End Rainproof GFCI (15amp)14-3 SJTW 15` long cord plug end GFCI GFCI Type    Power CordMounting    Cord MountGFCI Amperage    15AGFCI Style    Single Pole Single Throw...

Right Angle GFCI PlugDesigned for protecting spa units- keeps cords snug against the wall. Provides ground fault and open neutral protection

Harwil Q12DS Flow Switch 1/2" NPT with 2 amp pilot duty switches. Switches on at 10 gpm and switches off at 8 gpm. ABS body, stainless spring arm. Used to protect your spa from heating without circulation. When this switch fails your hot tub may show...

This Part is a Single Jumper Strap for a Balboa, EL, VS, GL or GS, Heater to Board connection.. This part is made from Copper.. Measures 2" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    EL,...

This part is a 31" AMP Style 4 Wire Cord With Male Plug that is used on a 2 speed pump.. The Wire colors are as follow on most systems: Red=High Speed Black=Low Speed White=Neutral or Common Green=Ground There are exceptions to these colors versus...