Hot Tub Parts of America

This part is a 45° 2" Street X 2" Threaded PVC Pump Union with Gasket or O-ring that matches Union. The Union glues into a 2" fitting on one side which measures 2 3/8" and...

This kit is a 6' Long RADKit® designed to go onto the outside of a 1 1/2" fitting and seal off the area between (2) 1 1/2" Fittings Outside to Outside.. An example would be if you had a Suction...

This kit is a 6' Long RADKit® designed to go onto the outside of a 2" fitting and seal off the area between (2) 2" Fittings Outside to Outside.. An example would be if you had a Suction fitting...

This kit is a 6" Long RADKit® Tight designed to go onto the outside of a 2" pressure fitting and seal off the area between (2) 2" Fittings Outside to Outside..   This RadKit is a tighter...

This part is a (1) 90° 1 1/2" Slip X 1 1/2"Slip PVC Plumbing Fitting. The 90° ELL receives a 1 1/2" fitting on each side which would measure 1 7/8" Inside Diameter. Any 2"  fitting...

This part is a (1) 90° 2" Slip X 2"Slip PVC Plumbing Fitting. The 90° ELL receives a 2" fitting on each side which would measure 2 3/8" Inside Diameter. Any 2"  fitting (which...

This parts is a (1) 90° 2" Street X 2"Slip PVC Plumbing Fitting. The 90° ELL receives a 2" fitting on one side which would measure 2 3/8" Outside Diameter and then slips into a 2"...

This part is a 1" Slip X 1" Street X 1" Street Tee X (8) 3/8" Barbs Air Manifold. The Manifold recieves a 1" pipe on one side and then slips into a 1"...

This part is a 1" Slip X 1" Street X 1" Street Tee X (8) 3/8" Barbs Air Manifold. The Manifold recieves a 1" pipe on one side and then slips into a 1"...

This tool is a Clam Shell Style Bearing Puller Clam Shell that you put over the bearing and use a puller to pull the bearing off the pump motor shaft... This tool works on 6203 style bearings only.....

This part is a CMP 2" Diverter Stem. This Diverter Stem is about 7/16" Wide sticking through the diverter cap. The Diverter Valve that this part fits is used to Divert Water into...

This part is a 1 1/2" Spigot X 1 1/2" Slip Slice gate Valve and 1 1/2 X 2" Heater Union with Gasket or Oring that matches Union. The Valve receives a 1 1/2" pipe...