Hot Tub Parts of America

This part is a Bushing Reducer 2" Street x 1 1/2" Slip converts a 2" glue in fitting into a 1 1/2" Glue In Fitting. For example you can install a 2" manifold in place of 1 1 1/2" Manifold by gluing...

This part is a Bypass Valve Flap made by Waterway found inside of In-Line, Top Load, Top Mount, Front Access, 2" Filter Housings... You will find these in several colors and they will have the...

This is part is (1) Stainless Steel cabinet panel screw for that can be used for many hottub side panels. This screw is a #8 with a 2" length with a Square Head and can be used with or without a...

This part is a Cable and Plug for an In.Link on system on IN.XE and IN.XM systems Aeware Gecko. The cable is for Pump 1, 2-Speed, 15A, 230V, 8' Cord. Cord Type Cord Appliance Pump, 2-spd...

This filter is 13 1/2" X 4 15/16" and has a female SAE Large Thick Thread that is 2" which would really measure about 2 1/4-2 3/8" ID. This filter is found in Some Newer Cal Spas and others. If you...

You are buying a Cal Spa Hot Tub Wing Pillow over neck jets for Some Cal Spa Hot Tubs that usually has 1480 cast into the back of the pillow. It is 16" long wing tip to tip, 2 1/2" Wide in the...

You are buying a Cal Spa Hot Tub Dark Gray Neck Pillow for Some Cal Spa Hot Tubs that usually has 1481 cast into the back of the pillow. It is 11 1/8" long Edge to Edge, 5" Wide on the edge...

This part is a Circuit Board, Balboa, CAL SPAS 6200 CIRCUIT BOARD Replacement. 8 PIN PHONE STYLE CONNECTION. CHIP NUMBER: CS6200R1(X) - CS6100R1(X) This circuit board replaces the discontinued CS6200...

This part is a Cal Spa Hot Tub Black Replacement Bottom Drain Cover and Screw.  This part has been discontinued so we have limited Stock.. This is for use in a Cal Spa Hot Tubs ONLY...

These are now obsolete now click this link for the solution.. You will not need all of these parts but we can't get it without them: Lo-Pro Floor Drain, 3/4" Slip Barb Ell, Dark-Silver-Glitter,...

Cal Spa 2" directional "Candy Cane" jet. This twist and lock two tone black and stainless jet insert is made by CMP for Cal spa and is in their Pro-Loc series. Easily identified by a small o-ring...

This part is a Cal Spa Cluster Storm, Jet Internal, Waterway, 2" face diameter, Textured 3 Scallop.. Note: This is a 2” Waterway Cluster Storm Jet.. Also these jets look very similar to CMP...