Hot Tub Parts of America

This part is a PVC Tee, 2"s x 2"s x 1"s.. You can make your connection back to the small side using the below kits..  Connect kit for 1" Soft pipe Click Here.. 1" Connect Kit Connect Kit for...

This part is a Tee, 2" Slip x 2" Slip x 2" Slip.. The ID of each connection is 2 3/8" and it will accept 2" Flex pipe in each connection.. PVC Pipe Fitting Type Tee First Plumbing...

This part is a Tee used with threaded bleeder Barb, 2" slip x 2"spigot x 3/8" fpt air bleed port to receive a threaded bleeder barb..  Barb sold separately see below for barbs...

This part is a Tee used to bleeder, 2" slip x 2"spigot x 3/8" fpt air bleed port and it does include a screw in plug with op-ring for the bleeder port.. PVC Pipe Fitting Type    Tee...

This part is a Tee that is 2"Slip x 2" Slip x 3/4" FPT.. This part is usually found in plumbing with spigot screwed into it.. Note there are 2 Spigot sizes 3/4" and 1/2" Threaded..   If you...

This part is a Tee, 3/4"slip x 3/4"slip x 3/4"slip.. This tee receives a piece of 3/4" Pipe or a street fitting that would measure about 1" Outside Diameter.. The Inside Diameter of the 3 fittings...

This part is a Tee, Reducing, 2"slip x 2"slip x 3/4"slip.. This part will receive into the slip fittings a pipe or fitting on each end that would measure about 2 3/8" Outside Diameter...

Temperature sensor for the Jacuzzi J-400 and J-1000 models from 2010 - current that uitilize the Nidec Spa pack that has the different colored rubber molded plugs, called a DSMT plug. This sensor has...

Temperature Thermister, aka temp sensor for the Watkins made Solana and Hot Spot hot tubs from 2003 forward. This sensor has a 3/8" bulb and a two wire, four pin JST plug that connects to the circuit...

This part is a Terminal Block 6 Position 40A 115 or 230V.. that fits Balboa Duplex Digital and Super Digital Board System with (6) Tabs to connect the board to the components.. 6 position terminal...

ThermostatsSingle pole rated at 25 amps with max temp rating at 107°F. Best results are obtained when the bulb is installed in a dry well or groove tube at or immediately before the heater. This...

Thermowell Temperature Sensor Mount in White. This dry well mount accommodates 3/8” temperature sensors from brands like Balboa, Gecko, Hydro Quip, and others. 1-1/4” hole size required...