Waterway Pump Impellers & Parts

Waterway Viper Pump 3.0 Impeller exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads...I have found this 3HP pump impeller to be on a 10amp motor... This pump uses a different seal than...

This part is a set of (2) 2" Pump Union Split Nut Repair Kits which includes the split nut, (2) Screws and a T Gasket for use with a 2" Pump Union. The Pump Union Split Nut that measures about 3" on the Inside of the threaded side and mounts to...

This is a Kit that features (1) PS-1000 Seal and (2) Bearings that fit most motors that are mated to Waterway Pump Wet Ends, The Professor silly Juice to seal the seal and a Tool to push the seal into place. This Seal is used in Waterway Wet...

This is a Kit that features (1) PS-1000 Seal and (1) Bearing that fit most motors that are mated to Waterway Pump Wet Ends, The Professor silly Juice to seal the seal and a Tool to push the seal into place.  This Seal is used in Waterway Wet...

This part is a Waterway Viper Pump 4.0 Impeller exclusively for A Waterway Viper pump which has 2 1/2" inlet and outlet which measures about 3 9/16" across the threads...I have found this 4HP pump impeller to be on a 12amp motor...   Closed face...

Tnei part is no longer available you can only order the complete wet end found Here: Wet End, Waterway, Uni-Might, Iron-Might, 1.0HP, 1-1/2", 48 frame, 1.4A/115v Waterway Iron Might Circulation Pump Impeller for 1/8HP Pump Closed face impeller made...

This Kit is an 1HP Impeller for an Executive 48 Frame Wet End up to 1HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

Waterway HiFlo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 2.0hp, it is used in a Waterway HiFlo pump wetend, and must be installed on a 2.0hp (or greater) thru bolt motor. Shaft seal sold...

Waterway HiFlo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 3.0hp, it is used in a Waterway HiFlo pump wetend, and must be installed on a 3.0hp (or greater) thru bolt motor. Shaft seal sold...

This item is a 3/4HP Waterway HiFlo Pump Impeller "B".. If Your motor is 115V the amperage would be about 11 Amp if 230V it would be about 7 amps..Closed face impeller made for the Hi-Flo side discharge pump by Waterway Plastics. Rated at...

Waterway Hi-Flo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 1.5hp, it is used in a Waterway Hi-Flo pump wet end, and must be installed on a 1.5hp (or greater) thru bolt motor. Shaft seal...

This Kit is an 2HP Impeller for an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 2 HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you...