Sundance Hot Tub Parts

This part is a Suction, Return, Wall Fitting, Jacuzzi, Sundance, Wall Fitting & Nut, Main Drain, White

This part is a Sundance Filter, 80sqft, 2"SAE Threaded Closed hole, 2-1/2" Open Hole, 8-1/2" X 14", Used with Roll Filter.. This filter is used the with plastic cage and the toilet paper roll style filter that goes over the cage..  For the...

This Nozzle Replacement Kit, Hydro Air, VSR, Roto, Gray can be used to replace some Hydro Air VSR Style Jet Nozzles on Sundance Hot Tubs and a few other brands.. The jet body this kit fits into has a 3 3/8" hole Size and the face width is about 3...

This Filter is 14-7/8" tall x 5" wide it has 2 1/8" holes on the top and bottom. This filter does fit some Cal Spas but looks very similar to a standard sized filter which is 13 5/16" tall but this filter is slightly taller at 14 7/8"...

This is a very unusual Air Manifold we have found in Sundance brand Hot Tubs nut can be found in others as well.. It is a 16-port manifold with (16) 3/8" barbs and 1-1/ 2" slip x 1-1/2"spigot or street meaning that a piece of 1 1/2" which measures about...

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing through the...

This part is a Temperature Sensor found in some Jacuzzi J-Series and Sundance, hot tubs that have Curled Finger Style connector..  See the pictures for the Curley finger style examples to determine if yours is that style....

This Filter is used in a Sundance Filter where this part slides onto a plastic cage that is screwed to the end of a filter and placed into the filter housing of a Sundance brand hot tub only..  For the filters and parts that...

This part is an O-Ring that is a square style.. It fits Piranha "A", Thera-Flo, Thera-Max, Bracketless, all found on Jacuzzi, Sundance, Hotspring and other brands as well...Part Type    Square RingO Reference Number  ...

This part is a 2" Slip X 2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union receives a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on the other...

This part is a Standard 2" Heater or Pump Union Gasket with a 2 1/2" Lip Center to Center. The gasket is 2 7/8" across on the outside the inside diameter is about 2 3/16" and the lip that fits into the union is 2 1/2" center to...