Heater Elements

In this video The Spa Guy shows actual voltage in the water on a hot tub and what caused it. a Missing ground on the GFCI box when the hot tub was wired!! Once again The Spa Guy Saves the Day!! Your Hot Tub Super Hero  #sparepair #hottubrepair...

This video is about The Spa Guy teaching you the basics of GFCI Hot Tub Wiring and the ins and outs of wiring a Hot Tub...  #sparepair #hottubrepair  #hottubhowto Save

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

This video is about The Spa Guy diagnosing a Breaker Tripping on a Hot Tub With Hydro-Quip Controls... How To Replace the Heater Element and final diagnostic verification of operation.... Save

This video is about The Spa Guy showing How To Remove a Heater Element where the nuts are spinning in the tube and will not turn off...... it is a similar process on all brands... Save

This Part is a 5.5KW Titanium Heater Element with (2) Heater Union Gaskets and a 1/2Oz Tube of Special Hot Tub Formulated Silicon Sealer to Seal the Threads. This Heater Element features the bend in the back of the element needed to fit the Balboa M-7...

This part is a 4.0KW Titanium Heater Element with (2) Gaskets and a 1/2Oz Tube of Special Hot Tub Formulated Silicon Sealer to Seal the Threads. This Heater Element features the bend in the back of the element needed to fit the Balboa M-7...

1" Screw Plug, Screw on TerminalsNo thermowells, 5.5kW/240v ratingCalSpa, Ramco1" thd elements measure 1-1/4" o.d

This part is obsolete..but we have a better option here: Jumper Wire, Heater Element, 10 gauge x 4", Board to Heater Jumper Strap to connect the heater to the circuit board on Balboa EL, GL, and Value systems. 2 required.   Heater Part...

This part is a Standard 3.0KW Heater Element 115v or 230V that features the bend in the back of the element needed to fit the Balboa M-7 heater tubes. This also fits Gecko, ACC, and most other standard Hot Tub Heater Tubes.   This part...

This part is a Center Mount 5.5KW Incoloy Heater Element for 230V or 115V Applications. Center mount means the holes for the electrodes are in the center of the tube to to one side or the other.. This is a very rare style but they are out there....

This part is obsolete..but we have a better option here: Jumper Wire, Heater Element, 10 gauge x 4", Board to Heater This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa LE and Value Systems. You can use this...