Wet End Pump Parts

This part is a O-Ring, Pump Housing Plug, JACUZZI, Pirahna/Theramax, 0.434"ID x 0.682"OD, .125"Cord Diameter.. Additional Information Outside Diameter .682 Inside Diameter .434 Type Standard Spa Brands Sundance/Jacuzzi

NOTE: This gasket does not fit your Coleman SALUSPA DO NOT order it.. Click this link to see Saluspa Gaskets.. Saluspa This is a Set of 2X Universal 1 1/2" Pump Union Gasket/O-Ring Kit. 6 Items total..  There are three possible sizes on a...

NOTE: This gasket does not fit your Coleman SALUSPA DO NOT order it.. Click this link to see Saluspa Gaskets.. Saluspa This is a Universal 1 1/2" Pump Union Gasket/O-Ring Kit. There are three possible sizes on a 1 1/2" Pump union measuring in the...

This Item is a Wear Ring, fits LX 1431501-03 Wet End Only. It may have a Vendor Code 3536 on the LX Brand Pump. These pumps usually have the part number 1431501-03 on the label for the 3536 Version. NOTE: Do Not purchase this for any other brand except...

This part is a Pump Shaft Water Slinger designed to sling water away from the motor front bearing in case of a seal leak and it fits All Brands of Hot Tub Pumps..   This part goes on the shaft before you install the wet end.. 

This Kit is a Set of (2) NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this...

This part is a Stronger Pump Bleeder Barb that fits some Watkins Wavemaster XP2, XP2E, LX and others.. It is 1/4" Barb x 1/4"Npt and is used with an unusual bleeder line.. The line is 1/4" Inside Diameter not 3/8" Inside Diameter like most bleeder lines....

This part is a Bleeder Barb with Silicone & O-Ring that is 3/8" barb x 1/4" Threaded MPT fitting fits Wet End Face Bleeder Plug Holes to attach a Bleeder Line it fits Waterway Executive 48 & 56 Frame Parts &...

This part is a Bleeder Barb with O-Ring that is 3/8" barb x 1/4" Threaded MPT fitting fits Wet End Face Bleeder Plug Holes to attach a Bleeder Line it fits Waterway Executive 48 & 56 Frame Parts & Wetends, Power-Right 9089X, 9094X,...

This part is a Pump Bleeder Barb for some Watkins Wavemaster LX Pumps and others.. It is 1/2" Barb x 1/4"Mpt and is used with an unusually large bleeder line.. The line is 1/2" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This...

This O-Ring is used on a Sta-Rite Pump, New Style Drain Plug, O-Ring, 1/2" ID, 3/32" Cross Section  Fits this style of plug only..  This plug is not included in this listing..   If you want the complete plug and O-Ring in this...

This part is found on a FMVP Vertical Circle Pump and is the O-Ring Between 4 Bolt Suction Plate and Face 2-3/8" ID 1/8"..