Aqua-Flo Wet Ends Complete

This Kit is a Set of (2) NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this...

This kit is a Air Bleeder barbed plug and Silicon sealer usually used on a Aqua-Flo and CMP Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands of Hot Tubs just compare the pictures and...

This part is a replacement wear ring found in 48 frame 1 1/2" Flo-Master "FMHP" Series Side Discharge and "FMCP" Center Discharge Spa Pumps.. The ring measures about 1 3/4" inside the wear ring and 2 3/16" at the widest part and about 3/4" tall....

This part is a 1 1/2" Slip X 1 1/2" Pump Union with Gasket or Oring that matches Union. See Pictures for measurements. The Union receives a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wet...

This part is a 2 1/2" Pump Union Gasket Only for use with a 2 1/2" Pump Union that would measure about 3 5/8" Inside Threads. This gasket measures 3 1/4" O.D. x 2 3/8" I.D. and the lip is 2 7/8" center to center. This version is the 4th most...

This part is a 2" Slip X 2" Threaded Pump Union with Gasket or O-ring that matches Union. The Union receives a 2" pipe or fitting on one side and then Screws to a 2" Wetend(Pump) Threaded Part on the other...