Complete Wet Ends

This Item is a Wear Ring, fits LX 1431501-03 Wet End Only. It may have a Vendor Code 3536 on the LX Brand Pump. These pumps usually have the part number 1431501-03 on the label for the 3536 Version. NOTE: Do Not purchase this for any other brand except...

This Kit is a Combination of the Two Standard Size 2" Heater or Pump Union Gasket (1) with a 2 1/2" Lip Center to Center and (1) with a 2 5/8" Lip Center To Center. The purpose of this Combo Kit is if you don't know which size you have...

This Kit is a Set of (2) NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this...

This part is a Bleeder Barb with Silicone & O-Ring that is 3/8" barb x 1/4" Threaded MPT fitting fits Wet End Face Bleeder Plug Holes to attach a Bleeder Line it fits Waterway Executive 48 & 56 Frame Parts &...

This part is a Pump Bleeder Barb for some Watkins Wavemaster LX Pumps and others.. It is 1/2" Barb x 1/4"Mpt and is used with an unusually large bleeder line.. The line is 1/2" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This...

This part is a replacement wear ring for Wavemaster 5000 Pump Impellers with a 1 3/4" Eye.. The ring measures about 1 3/4" inside the wear ring and 2 3/16" at the widest part and about 3/4" tall..   The below List is other parts related to this...

This part is a replacement wear ring for Wavemaster 3000 Pump Impellers with a 1 3/4" Eye.. The ring measures about 1 3/4" inside the wear ring and 2 3/16" at the widest part and about 3/4" tall.. For Other related parts see the below...

This Part is a Barbed Bleeder Barb with O-Ring that fits New Style 48 or 56 Frame WUA Intertek LX Brand Pump Wet End that uses a fine thread bleeder plug.. Watch the video for instruction on how to install this part and also how to...

This Part is a Barbed Bleeder Barb with O-Ring that fits New Style 48 or 56 Frame Intertek LX Brand Pump Wet End that uses a fine thread bleeder plug on Jacuzzi and Sundance Brand Tubs.. Watch the video for instruction on how to install...

This Kit is a Air Bleeder 1/4" Mpt X 3/8" Barb plug and Silicon sealer usually used on Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands of Hot Tubs just compare the pictures and...

This kit is a Air Bleeder barbed plug and Silicon sealer usually used on a Aqua-Flo and CMP Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands of Hot Tubs just compare the pictures and...

This part is a replacement wear ring found in 48 frame 1 1/2" Flo-Master "FMHP" Series Side Discharge and "FMCP" Center Discharge Spa Pumps.. The ring measures about 1 3/4" inside the wear ring and 2 3/16" at the widest part and about 3/4" tall....