Four Winds Brand Hot Tub Parts

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts,...

Balboa Water GroupStainless steel replacement heater assembly, 5.5kW/230v, 2" x 15". Includes a pressure switch, Hi Limit Sensor on the right side. Made for Balboa Value and Balboa LE control systems. Housing Configuration  ...

This 1" CMP Waterfall Control Plunger Replacement Kit that includes the Cap, Handle, PLunger Assembly and o-rings.. This kit is found in some 1" CMP Waterfall or Neck Jet Control valves.  NOTE: This Plunger looks a lot like the Waterway Brand...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a 100 Square Foot Filter Cartridge that is 17 13/16" Tall x 6-9/16" Wide with a 2 3/8" Hole on Top and Bottom it can be found in some H2O or Four Winds Swim Spas and many other brands as well. Application    H2O Spas,...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Balboa 6 Button Overlay for a Topside for a Two Pump with Light System. On the overlay starting at the left of the readout it reads Jets, Jets, Light and Warm, Mode, Cool. This Overlay can be used to replace your original Overlay with...

This part is a Black 3 1/4" Long Catalina Spa Diverter Handle Knob only. This Diverter Knob mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The Diverter Valve that this part fits...

This part is a Hot Tub Pillow that is 9 1/2" x 4 1/4"  and 6-1/2" between the Tabs it fits a variety of brands some are out of business. It fits some Infinity, Raindance, Serenity, Premier, Serenity, Dimension One and Also Four Winds...

This Part is a Black 2 5/8" Face Width Replacement Mushroom Knob for Waterway, Hydro-Air or CMP Brand Waterfall Control Valves.. The Bottom Accepts a 5/8" wide Square Stem and we offer these in Black, Gray and White.. See the link below....

This item is a Black Handle used on a Waterway Waterfall or Neck Jet control only.. Note: this looks similar to an Air Control Handle but they are different.. The main thing is the Square part that slides on the valves stem it is about...