Cal Spa Hot Tub Parts

This part is a Filter Basket found in some older Cal Spas.. Basket Type Skimmer Application Manufacturer Waterway Application Model Top Mount Skimmer Basket Height 5-5/8" Bottom Outside Dimension 5" Top Inside...

This Filter is 14-15/16" wide x 14 7/8" tall it has 2 1/8" holes on the top and bottom.   Application Fountain Valley Spas, Martec/Sonfarrel, Santana, Sonfarrel/Advantage Bottom Physical Dimension 2-1/8" Bottom...

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This kit is a Set Of (4) Bolts and Grommets For A Cal Spa Hot Tub Front Access Panel Door.  The Bolt is 2" In Length And The Grommet Has 3/4" Diameter.  

This part is a Cal Spa Safety Suction Tee Fitting that has a 2" Pump Union that would measure about 3" Inside Diameter X 2" Slip Fitting that is 2 3/8" Inside Diameter with a 1/8" MPT Tap on the top to receive a Safety Suction on Top.. Note: The Cal Spa...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This part is a Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (2) Small O-Rings that fit on the Stem sealing the inside of the cap and (1) Large O-Ring that seals the outside of the cap and it fits many different brands The...

This item is a (6) Way Barbed Coupling used to couple 3/4" main hoses and 3/8" ID hose together. 3/4 Inch Barb X 3/4 Inch Barb through and (3) tees Barb Coupling 3/8" barb and 3/8" barb... This part is used on pump bleeder systems many time where the...

You are Buying a Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply adding silicon...

This Kit is a Silicone Kit & Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply...