Complete Heaters

This part is a O-Ring, Pump Housing Plug, JACUZZI, Pirahna/Theramax, 0.434"ID x 0.682"OD, .125"Cord Diameter.. Additional Information Outside Diameter .682 Inside Diameter .434 Type Standard Spa Brands Sundance/Jacuzzi

This part is an Adapter, Drain Plug, Sundance / Jacuzzi, 1/4" MPT x 3/8" Ribbed Barb, Stainless Steel, Less O-Ring.. Used on Various J-200, J-300, J-400, J-500, J-LX Series Spa Pump HeadsO-Ring is Required, Teflon Tape Not Used Click here for the...

Note: If you can't measure your heater union groove size we offer a set with both sizes Click this link: Set of (4) Hot Tub Spa 2" Heater or Pump Union Gasket Combo (2) 2 1/2" Lip & (2) 2 5/8" Lip Gasket This Part is a Set of...

Red Epoxy is a new high performance, two-part, heat cured, epoxy repair kit for making permanent repairs on all metals and rigid plastics. Red Epoxy is specifically designed to exhibit a distinct color change when heat cured. Red Epoxy will provide a...

This Kit is a 2" Heater Union, Slice Valve, Spin Kit with Glue To Plumbing Connect Kit found in many Hot Tubs. The Heater Union which measures about 3" outside the threads receives a 2"street X 2" Slip Slice Valve then you glue the 2" coupler to spin it...

This Kit is a 2" Heater Union, Slice Valve, Spin Kit To Plumbing Connect Kit found in many Hot Tubs. The Heater Union which measures about 3" outside the threads receives a 2"street X 2" Slip Slice Valve then you glue the 2" coupler to spin it to win it...

This part is a Ground Bar found on many Balboa Brand Spa Hot Tub packs as well as some Gecko SSpa and Mspa packs.

Brass Fitting that fits an 1/8" MPT Jacuzzi heater fitting on one side a 3/8" ID tube on the other side. I have seen these in Jacuzzi Premium Trombone Heaters to attach the heater to the bleeder system though there are many applications this can be used...

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa B2DG and B240 Systems.   Circuit Board Application    Balboa Water GroupCircuit Board Model    B2DG, B240Circuit Board...

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole...

This part is an Barb Replacement Kit for Watkins, Hotspring, Tiger River, No Fault Heaters.  Make sure heater looks like these it does not fit all heaters..  Below is a list of related parts click on the links for each...

This part is an O-Ring Replacement Kit for Watkins, Hotspring, Tiger River, No Fault Heaters.  Make sure heater looks like these it does not fit all heaters..  Below is a list of related parts click on the links for...